Crest Audio X-VCA Manuel d'utilisateur télécharger pdf (Page 59)

p. 59

left / right & mono master modules

features

Aside from their Left / Right and Mono assignments, the X-VCA Left / Right and

Mono master modules contain identical features. One module is devoted to the

Left and Right stereo mix and the other module is devoted to the Mono mix.

Both modules contain the following sections:

* Matrix Output Control

* Matrix Send 1 though 4

* Output EQ

* RMS Output Limiter

* 100mm Faders

* Microprocessor Mute Controller

* Solo

Matrix output control

The Left / Right master module contains Matrix Master 1 and the Mono master

module contains Matrix Master 2.

mute

Mute switch

See LOCAL MICROPROCESSOR CONTROL section

Matrix master output level

The MATRIX MASTER output level controls set the levels that appear at

the corresponding MATRIX output connectors on the rear-panel.

Talk to

Adds the TALKBACK system output to the associated MATRIX output.The

level of the TALKBACK signal is set by the TALKBACK level control in the MAS-

TER section.

solo switch

Pressing this momentary switch will include (illuminate) or exclude (not-illu-

minated) the channel from the consoles solo system.

See SOLO FEATURES section.

write-in label

This label may be written on with a grease-marker, or dry-erase pen and later

wiped clean. Masking tape may also be placed on this surface, if desired. If you

write on it with a "Sharpie", you may have trouble getting the writing off. If this is

the case, your best bet is to wipe the label off with isopropyl (rubbing) alcohol.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 141 142

Pas de commentaire

Crest Audio X-VCA Manuel d'utilisateur Page 59