Crest Audio X-VCA Manuel d'utilisateur télécharger pdf (Page 91)

p. 91

microprocessor control

Mute controller

A)Up/Down

Each press of these switches increments or decrements the Patch Display

(B). Holding either button down will allow quickly scrolling up or down.The

buttons are also used to select the parameters and settings of the system

while in Utility mode.

B)Display

This 4-character alpha-numeric display normally shows the current Patch (1

through 128) being recalled. It is also used to display the parameters and

settings of the system while in Utility mode.

C)Edit Preview

Pressing this switch puts the system into Edit/Preview mode, allowing the

operator to view and change the contents of any selected Mute Scene.The

internal red LED will blink while in this mode, along with the status LEDs (J)

of any channels assigned to the selected Mute Scene. Pressing a Channel

Mute Sw (K) will add or remove a channel from that Scene. Pressing the

Edit/Preview switch again will exit back to normal operating mode.

D)Edit Safe

Pressing this switch puts the system into Edit Safe mode, allowing the oper-

ator to view and change the contents of the SAFE memory.The internal

green LED will blink while in this mode, along with any channels assigned to

the Safe Scene. Pressing a Channel Mute Sw (K) will add or remove a chan-

nel from the Safe Scene. If a channel is included in the Safe Scene, it can’t be

muted from a Mute Scene.This allows the operator to remove a channel all

Scenes without having to edit any of the Scenes themselves. Pressing the

Edit Safe switch again will exit back to normal operating mode.

E)Single Scene

There are 9 mute sources available from the Mute Controller: the 8 Manual

Mute Scenes (H), and the Micro Scene (G). Normally any or all of theses 9

sources can be active at one time, which allows the operator to combine

different mute patterns.The Single Scene switch, when depressed, permits

only 1 of the 9 sources to be active at one time.

F)Micro Utility

This latching switch will put the system into Utility mode.The operator can

then access and view the various parameters and functions of the controller

using the Up/Down buttons (A) and the Display (B).

G)Micro Scene

This switch activates the Sequenced Scene (Patch).The display (B) shows

which of the 128 possible Scenes are active.

H)Manual Mutes

These 8 switches activate the associated Manual Mute Scene.Additionally,

these switches, along with (G), select which Mute Scene is being edited

when in Edit Preview Mode.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 141 142

Commentaires sur ces manuels

Pas de commentaire

Crest Audio X-VCA Manuel d'utilisateur Page 91

Commentaires sur ces manuels

Produits connexes et manuels pour Mélangeurs audio Crest Audio X-VCA