Crest Audio X-VCA Manuel d'utilisateur télécharger pdf (Page 117)

VCA assignment 2 Detailed Operation

There are two methods for doing VCA Assign on the X-VCA.

Note: Front Panel Switches are indicted by BOLD-HYPHENATED-CAPITALIZED-

TEXT. For the 8 VCA Masters, the switch to select the Master for editing is indicat-

ed by " EDIT-VCA#-ASSIGN", # represents a number 1 thru 8.This second method

assigns Masters to Channels:

One of the 8 VCA Masters is selected and its assignment to all of the Channels can

be viewed at a glance.The assignment to that selected Master can be cleared, and

changes can be made as needed.A new Master can then be selected for viewing /

editing, or the same Master can remain selected and the Scene number can change

(using the Scroll Buttons). For this second instance to occur, the VFS switch must be

down and steady Red. If the VFS switch is not depressed, or if it is blinking Red, the

assignment changes will only affect Scene-0.

VCA Assignment- Masters to Channels:

1. Starting with the Console in NOM Mode, one of the 8 EDIT-VCA#-ASSIGN switches is

pressed.

2.Any Solos that were active are cancelled, the Console SOLO system is disabled.The

Channel Status LEDs switch over to display VCA Safe status.

3.The selected EDIT-VCA#-ASSIGN sw begins to blink, indicating that the Console is in VEM

Mode

4.The VCA Assignment and Mute data for this Edit will become active, replacing the prior,

Normal Data.

5. If the VFS Sw is UP, any edits are performed on Scene-0, If VFS is Down (lit RED), the edits

will apply to the Scene number indicated on the display.

6.ALL Channels that this Master is assigned to (for this Scene) will have their SOLO LEDs

blinking.

7.The user can then view the Master’s assignment by observing the blinking LEDs of the

Channel Solo switches.

8.The User can choose to Clear the assignment (un-assign ALL Channels) by holding down

the currently selected EDIT-VCA#-ASSIGN switch for at least 2 seconds.All assigned

Channels will then be un-assigned for this Master for this Scene. Note:There is no indication

or warning that this Clear will occur, so be cautious.

9.The assignment can be changed by pressing any of the Channel SOLO switches.The LED

will change state, assigning or de-assigning that Channel to that Master. Only Channels can be

assigned to a VCA Master, so only Channel SOLO switches have any effect at this time, other

non-relevant SOLO switches are ignored.

10.The next Master to be viewed can now be selected by pressing its EDIT switch- Go to

step 3

OR- the same Master can remain selected and the next Scene assignment viewed.

11. Use the Scroll Up/Down arrows to select another Scene to view (if VFS is Down).The

current assignment will automatically carry over to the following higher numbered Scenes,

that assignment can be edited and then the edited version carries over to any higher num-

bered Scenes.

12.The user scrolls to the desired Scene and changes the assignment as in Step 6.

13.To exit VEM Mode, the currently selected EDIT-VCA#-ASSIGN switch is pressed again. It

stops blinking, the Console returns to NOM Mode.The initial Scene # is restored if a scroll

button changed the Scene # during the Edit process –OR- The user can press the EDIT-

CHAN-VCA-ASN button and jump directly into VCA Assignment Method –1 (see previous

page).

p. 117

vca facilities

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 141 142

Commentaires sur ces manuels

Pas de commentaire

Crest Audio X-VCA Manuel d'utilisateur Page 117

Commentaires sur ces manuels

Produits connexes et manuels pour Mélangeurs audio Crest Audio X-VCA